Recent content by mrploww

Thanks. He said he went with 15x8 all around, so wanted to see what he did front/rear BS.

Backspace front/rear?

Tire/wheel size and backspace?

I am adding a Hemi fiberglass scoop to my '64 Belvedere. I am trying to decide if I want the peak on front of hood where ornament and sphere were removed for a clean look or just leave it. Has anyone removed that on a '64? Thanks!

Ok, thanks. I bought a '65 Hemi scoop from Hemi Eddy and it does not have studs. It has tabs that use a clip that screw goes into. What are your thoughts on either style? I want something that will hold on with no issues and also not rattle against hood and chip the paint.

How do the AAR fiberglass scoops mount? It appears they have some sort of studs on them.

I sent you a PM to email me some pics if you can. Thanks!!

Centerline, do you have pics of the scoop finished and installed on your car? I am getting ready to put one on my '64.

Is anyone running 18/20 combo? I would love to see some pics. I am debating on 18s all around or 18/20 on my '64 Belvedere wagon. Wheels are so hard to choose!

Looking for passenger door front upper door hinge for '64 Plymouth. My car is a wagon, so would need one from a 4 door, but the upper front passenger side, the one with the spring thing that keeps door open.

Well, figured out it was just stuck from sitting. Took a little force but everything is turning fine now. It was rebuilt 2 years ago and had been sitting, so makes sense. Thanks for the tips and advice! If there are more issues, it is going to A&A! You get what you pay for and I have...

Thanks for all the advice! We did not try to turn it before trans was installed, should have done that now! Input shaft did turn. We are using a Gen3 hemi ATI flexplate for 727. Converter is a Dynamics Convertor. Engine turns over fine, so no binding there. Going to try the stuff suggested here...

Thanks, I will check the rear band. Hopefully it is something simple or it will be going to A&A for rebuild.

Hey, working on a Gen3 Hemi swap in my '64 Belvedere wagon. I wanted to keep the push button, so bought a "rebuilt" 1965 small block 727. We are getting close to firing the engine. Just had a slip yoke driveshaft made. Installed driveshaft, but cannot turn output shaft. Car is in neutral and no...

1964 Plymouth station wagon gas tank. These are extremely rare since they mount in rear quarter panel. This should fit other years but check your application. This came from my 64 Belvedere wagon. Tank was sealed in 2005 and never had any leaks. Removed it to go with a custom fuel injection alum...