Recent content by MTBRider

I think I could put at least a couple of them to use as I’m missing some from my 67 Coronet. Color is wrong so I would try to dye one to see if I can make it look ok. I’m going to be in the Portland area over Memorial Day weekend but my guess is you’re too far, what would you charge total if...

From a 1/3 mile clay oval circa 1979ish. 426 wedge, went like hell down the straight but pushed into the corners. All steel car, pretty heavy.

We live in town but have a few foxes around

I’m considering sending my distributor out for someone with the ability to verify condition and rebuild/recurve if needed.

It’s a basically stock engine with a lot of miles and I think compression is down a bit. I put in a limiting plate to reduce total timing and I run 92 pump gas. Going to install the AFR gage soon as try to tune better this spring.

Search “old car knock sensor” and you’ll see some options for aftermarket units.

Not sure, I could hear it occasionally. I picked up an AFR gauge for better tuning this summer to hopefully use it with some timing adjustments solve the problem.

No, that pic is going through the spark plug hole

I was surprised on how good the image quality is and that you can record video or still images. Great addition to the toolbox

Just purchased a Vevor borescope from Amazon for about $60 and so far very happy with it. Build quality and image quality seem very good. Rechargeable, long camera cord, three lenses on a 8mm dia tip (front and two sides all with lights) and even comes with a 32 gig micro sd card. Here’s two...

Finally purchased a borescope and this is what I saw. I assume this is due to detonation which I’ve been struggling with occasionally. Can anyone confirm by this pic?

If that’s the 70 Challenger, my buddy got it. I hope to drive it this summer!

Son’s first ride