Recent content by pedal2themetal

HI thanks that makes more senses as there is only one big post in the relay I kinda thought that's what he meant.

OK FINAL EXAM.. BOOOHOOO flat cam lobe. Pulled the valve cover and #8 exhaust valve doesn't move but just a little. push rod straight ... lifter looks to be down in the hole compaired to all the others ...BOOOHOOO... While it was running not much oil movement thru out the valve train Not...

HI, Where do I hook up a remote starter to turn the motor for inspection of valve train. I see a connection block on the firewall but don't know which wires?? Oh 1975 Fury.

HI, Yeah I started it this afternoon and pulled plug wires one at a time and moved the throttle and the first one I pulled was #8 and it stopped popping .. all the others no change in popping .. So #8 is my problem cylinder... I may have warped a Valve as that cylinder is right where that EGR...

HI, Yes.. because you can let the clutch out some to load the rear end so it doesn't get that hard shock.

Hi Never saw one in action?? might work??

HI, Nope.. motor runs smooth. just pops out the intake when giving a little throttle like 1/4 throttle. Vacuum gauge is quite steady only vibrates 1# 13.5 to 14.5 at idle 750 rpms.

HI, If you mean spark plugs just stock heat range

HI, OK... the plug in the back of the exhaust crossover did quite the under hood noise a little. but not the problem.. At this point this weekend I'm going to pull the VC's and check it out I'd almost bet I got a broken spring..but we'll see. Springs are a new set of 901's.. as suggested by my...

HI, OK. Plugs looked good but I replaced them anyway... didn't change anything. still popping.. Vacuum gauge was good only bouncing very little 1 Lb 14.5 to 13.5 .. so I took a stethoscope to it and found a bad leak in the EGR system I had plugged up. I made some plugs to go into the EGR cross...

HI, for the over heating I replaced the radiator with one from ECP (Enginnerd Cooling Products). Now it barely gets over the 1/4 mark on the gauge with a 185* stat. going to go up to a 195* stat. I replaced the oil and filter and the idiot light went away. so It was the oil loosing its...

HI, Ok I've got the over heating under control .. but now I have a loss of power and when I get on it I have that Blap Blap sound in my exhaust? did the times of overheating hurt my motor???? it seamed to be fine right after I fixed the over heating but now its doing this? and the idiot light...

HI, Ok.. I went to test the light and I pulled the wire off the sender. and went to push a wire into the connection and the wire broke off. So I'm guessing that was the problem.. HOPING easy cheap fix...

HI, I just need to check that the light is working... While I was driving the motor didn't get noisy like it lost oil pressure, but the light came on the went out and came on again and went out, now it does not come on with the key in the on position with motor not running ... I'm hoping its...

HI, can I just pull the wire off the sender and ground it to see if the light lights up?