Recent content by Tim2266ev2

What are you using for valley pan gaskets since you opened them up to max wedge size? I was using andy f's ar engineering valley pan and "bat wings" when my 240s were standard size, just wondering what combo you used for valley pan and intake gaskets. Thanks in advance

I just went through the same thing with them. They will not replace, only redcoat. Polished 2 inch 440 headers with the thermal barrier coating... any idea who you spoke to?

What kind of starter is that?

Where are you located?

Thanks!

What dipstick is that? Car is beautiful

What gaskets are you using on your batwings? Fel pro or Hughes with the silicone seal?

Looks great. How did the 3 inch tailpipes fit between gas tank and rear frame rails? Tight?

What headers did you end up running on your trick flow heads?

Good to know. Thanks

Thanks guys. I appreciate the replies!

It's what I'm going to end up doing, sometimes I have a tough time with that top clip on the coupler. I was just wondering if the inner shaft was the same length

Hello, I have a 66 coronet that is currently column shift with power steering. I bought a floor shift power steering column to replace it since i changed over to floor shift. The column I bought was complete with the shaft and coupler. New shaft Coupler seems to have a lot more slop than the...

Hello, looking to trade or sell my 1967 coronet floor shift power steering column for a floor shift power steering column for a 1966 coronet. Very good condition, Includes original turn signal switch and lever, mount bracket. Has been painted black, but done well. Pics to come later today...

Hello, I was wondering if you have door lock link rods and clips for a 66 coronet? These go from the lock cylinder to the latch. Please let me know. Thanks