Recent content by tvtn

My car: non rally dash, 69 Road Runner,OEM non Air conditioned, soft pad, Installing Classic Air kit for non AC car. Hope I didn't miss anything. Thanks for all the replys.

Everything,pad, bezel, and air outlet. I can get the air outlet from Classic air new. Please tell me what you have, and condition. Thanks.

I'am looking to purchase a driver quality lower dash pad,bezel, and air outlet for factory AC equipped 68-70 b body cars. Black preferred, but not absolute. If you need a black non AC lower pad to trade,let me know. If you have all or any of these parts, let me know. Tom

Thanks all for your replys

I am closing up the trunk and interior floors and wanted to know who sells a "complete" without buying excesses of useless rubber and plastic hole plugs. A location guide and type of plug, (rubber or plastic) would also help. I can't seem to find anything on this forum. Thanks in advance for...

I have a 69 RR with a Gerst tube front end with a 440 going in. I'am worried the Eastwood radiator I bought may be back too far towards the water pump front, including an (electric fan). Could someone measure from the firewall to the tip of the water pump on a normally mounted big block? That...

Well, never having owned a four gear car, I may be missing all the fun,but a hard shifting 727 can be fun as well. Thanks for your post/

Have a 69 RR with 4 speed floor tunnel, going to TF, anyone modified the factory tunnel for the auto trans?

Thanks for you replies, computer out of service for a while.

I've got a Gerst tube front end ready to go into my 69RR. What I'd like to do is brace the front frame rails in a "triangle" from the firewall to the shock tower and weld to the forward end of the frame rails. I know Magnum Force makes a "kit" to do this but I'd like to know if anyone on the...

Thanks to everyone for your replies about the minitub/seats mods. Tom

I mini tubed my 69 RR, and wondered what mods were needed to fit the rear seats???

Joe Thanks for the photos and measurements. The 4" measurement from the bottom of the floor pan to the ground side of the Martz shock mount agrees with mine. You said that that same mount is 3/4" from the gas tank mount? Where mine sits is 1" from the rear side of the shock mount square tubing...

Joe I think I have the rear crossmember set correctly,but would still like your input regarding the distance between the rear of the new crossmember and the front of the gas tank mounting area or any other point of measurement. I bought a 50"X 3" pipe to mimic a 3rd member and mock up the coil...

Joe Wondered if you had time to measure the distance from the back of the Martz rear cross member to the surface of the trunk area, or to any other common B Body frame points? Thanks for your help so far.