Installing rear glass & trim on 69 RR
- Thread starter AFB
- Start date
- Local time
- 2:56 AM
- Joined
- Jan 29, 2018
- Messages
- 19,436
- Reaction score
- 63,601
- Location
- Midland Ontario, Canada
3/8" Butyl ribbon and don't forget to use a few rubber spacers along the bottom edge. Test fit on 3/8" blocks first to get glass centered, use masking tape across glass to body for alignment and then cut it so when you put it in for real you line up the tape lines.
I've always liked the 3M 3/8" X 15' kit. looks just like the kit you're using
for around$18.00. It comes with the two spacer blocks.
for around$18.00. It comes with the two spacer blocks.
droptop
Well-Known Member
Put the trim on before the butyl sets up so the glass height will be correct. Let the trim determine how far you smash the butyl down. I have had to cut a glass back out before because the butyl set up and the glass was not deep enough to get the trim on. :2cents:
Similar threads
