Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I used Diamond Power brand from E-Bay. Very cheap but, professionally packaged, looked and spec'd good. Made in India but, they do build 100s of thousands of cars there. I couldn't find any other rod bearings for my 2008 3.8 V-6 so I ordered a set and have 3-4 thousand miles on so far (it's my...
This amount of misalignment may not bother operation if you are not driving aggressively. Belt drives can work with small misalignment, not ideal but, it will depend on RPM.
Mike
Not really. Chrysler used the same style gaskets through out the B engine production. Did your machinist finish for the steel gaskets or composition type gaskets?
Mike
Up in my neighborhood it used to get down as low as -40* and tens of thousands of people would drive their standard transmission vehicles to work on those cold mornings!
Mike
I just wanted to add a tip for fellas using the Autometer water temp gauge (electric). Buy another sender unit for the trans and wire the two senders to a DPDT toggle switch. Now you have one temp gauge to read either coolant or transmission fluid.
Mike
Did it shift OK before the reseal? Who replaced the seals? Was it a quick and dirty seal job? Could be a dirt issue. You need to check pressures to properly diagnose your issues. Were the clutch seals replaced too? We need lots of info here!
Mike
I first learned about driveline angles in 1970 after braking two extension housings and a bell housing! I had a 63 Savoy with a 59 413 and "cast iron" torque flite. Some of my dad's buddies did the swap for me while I was at school. I was studying drive lines at the time!
I really wished I had...