Search results for query: *

Looking for a 63 or 65 Plymouth b body rust free trunk lid . Thanks

This is on 63 Plymouth bev. , had to replace right side door glass channel that the glass sits in , got one from a 64 , same thing but the window channel is not as wide as the 63 was the glass thinner?

Looking for 1963-65 b body 2 door sedan front pass side window glass channel.

This is on a 1963 b-body , how to disassemble the bottom part of vent wing pivot assembly , have latch off . Going to replace with new chrome pivot bottom assembly. Seen somewhere how it is done and search everywhere can't find it . Thanks

Have 63 B-body single speed wiper motor, all clean and painted, tested it, it runs but try turning it by hand and its hard to turn is this normal? Does anybody rebuild these or can you buy remans ? Thanks

Both steering shafts are for power steering and couplers on both , one is from 63 and 64 b body car , got them mix up ,one is half inch longer, need length for the 63. Thanks

Looking for 1963 b -body 2 door sedan post drivers door .Thanks

Was going to use two stage paint now going to use single stage , question is what to use , they had three types, acrylic enamel , acrylic urethane , urethane , what is best one ?

What seam sealer to use in roof gutters , how it wrote down a while back but lost it somewhere , believe it was something about self leveling , used Wurth on inside body seams . Thanks

Somebody wanting to sell me a 1975-77 TQ carb , came off 440 and number on it is 2472 , don't know much about these carbs , seeing if it was worth buying , its all there together ,dirty , he's wanting $100 for it . Should I buy it or pass . Thanks

Has anybody mic the rear main oil seal journal on a knurl and smooth 440 crankshaft to see if the measurements are the same ?

This is on a 63 b body , got all the seam sealer off the whole car except in the roof gutters , this isn't coming off like the rest of it did , try heat gun , no go , wire wheel . putty knife ,razor knife , screwdriver takes forever and still can't get it all , it's different seam sealer then...

Was checking out another forum and this person said has engine was running hot , he put new head gaskets on it and he said he drill 2- 5/8 inch holes near exhaust and 3 -1/2 inch holes near lifter valley in his head gaskets and said runs cool , stays at 180 , never heard of this before ? Does...

Looking for 727 valve body 2801856 . Thanks

What is the exhaust pipe clearance between bottom of floor to top of pipe or what is recommended ? Thanks

Did all 1966 dodge coronet have rearends 8 -3/4 741 and 742 ? Going to buy one off this guy he doesn't think its a 8 -3/4 . Google it couldn't find out if they came out with 8 -1/4 or different ones ? Thanks

Who has a 65 Plymouth satellite ,big block ,727 trans. ,742 diff . need the measurement from center of u-joint hole to center of other u-joint hole on driveshaft . Yes ,I look at the sticky on driveshaft length , don't list 65 on down . Thanks

What's the part number for the double lip 742 pinion seal ? Had it wrote down , can't find it . Thanks

Looking for a 1963 b-body sedan 2 door post ,driver side door . Thanks

This is on a 63 b body , would the stock fire wall insulation be better then Kilmat reason asking if I use the kilmat going to weld up holes where the pins fasten the stock insulation on , hate to weld them up . Wonder if I could use seam sealer on holes ? Thanks