Search results for query: *

What year is your car Ray?

Here's what I used! Got it from allpar I believe

Thanks for the reply. Did the seats sit higher than stock? You wouldn't happen to have a picture would you?

Anyone??

Thanks very much for the info Force Fed! I'll call MSD to see which sensor I can use. When I get it all hooked up I'll shoot you a message with a couple more questions if you don't mind?

Thanks for the info! Ok, I've got a bunch of questions for you but I'll just start with a couple haha. -A 1 bar MAP sensor should be good for me where I'm not running any boost correct? -Do I put less timing advance in it when the vacuum is high? Like say cruising on the highway at 3000rmp?

It's time for a clutch upgrade in my 71! What do you guys recommend? I plan on running around 550HP after the winter so I need something that'll at least hold up to that! Thanks!

I did some more reading on the map sensor and I found one that'll plug right into the box and I can plum to a manifold port on the rear of the manifold. I'm not completely sure but I think it's only use is for timing control in boosted applications. I'll have to give the MSD tech line a call on...

Thanks for the input Force Fed. I did what you suggested with the ramp and then bumped it up to 36 total and kept the initial at 20 and what a difference! I saved another 4 degrees of advance on the box so I have that much adjustment without having to move the distributor when I get it on a dyno...

Greatly appreciated mlktst! Just like I pictured it. I'll do mine the same way!

haha no problem. Shoot me a message if you need any help!

Thanks for the quick reply! I guess that'll have to do although I would prefer a non locking one.

Does anyone know of a vented gas cap that will fit my 71RR? Possible even a part number? I've done a bunch of searching but I cant find anything that'll fit for sure. Here's a pic of my current non-vented cap...

yes it does have a plug for a map sensor but I'm not running one because I didn't know a way to jimmy rig one to the old dual plane manifold. The MSD tech said it's not mandatory to run one. Do you think I should? If so do you have any suggestions on one that I couod rig to my manifold? thanks!

Thanks for the input guys! Finally got it up and running yesterday morning and its hard to believe the difference in drivablity at low speeds and idle! I'm happy with this timing curve so far but she doesn't seem to have the same pull above 4000 so I'll bump the total timing up to 36 and try that.

That's awesome and sounds like a great idea! Did he have to change the fuel bowls or did he just tap the ones you already had? If you could get a couple pictures for me it would be greatly appreciated!

Good to hear! I'm curious how he set it up... Did he use a regulator after the carb or did he restrict the amount of fuel going down the line with a small orifice?

So I'm right in the middle of swapping the stock igniting in My 71 RR for a MSD 6AL2 Programmable unit. And I need to make the advance curve with the provided software because it doesn't come with a pre set curve. Picture attached is what I've come up with so far... I was thinking I'd set my...

Does anyone have any first hand expirence with an aftermarket bucket seat bracket that actually fits? Was going to get a set of Procar Rally seats with their brackets but apparently after reading a bunch of reviews the brackets dont even come close to fitting? Thanks for the help!

I ended up finding this and your build thread in a search! Nice work! - - - Updated - - - Interesting, I didn't even know Hotchkis made a sway bar for the 71 and up b bodies? Do you happen to have a picture of it installed? Is it mounted above or below the axle?