Search results for query: *

Been half way thinking of getting a ex-police Charger. Looking at 2019 -2020 with the 5.7 and AWD. seeing them in the $18,000 to $21,000 range with 50-80K miles. Being honest not really sure why, but it won't be an every day driver, maybe call it an advanced all weather/purpose beater? Anybody...

Winningest European Chrysler Hemi 'Cuda is back Trying this again......OK, looks like I figured it out. Stumbled across this and though it might have some interest here. Yup I know it's an old story.

Have a 66 Belvedere 273 2 barrel automatic, been having a bit of fuel leak around bowl gasket and decided to pull the carb run it through the ultrasonic and install a kit. Turns out the carb on it, number 4957s is showing to be off early 70 318 pickup trucks. Now it really doesn't matter as it...

Anybody here ever had stuff done by this shop ? http://microautogroup.com/ChromeHome/ChromeServices Got a couple of bumpers to have done and the shop is only about 75 miles from home for me. Would save the shipping costs. Thanks

Installed new carpet in my 66 Belvedere II a while back. Did not find a build sheet but what looks like a inspection sheet, pictures attached. Any place else the build sheet might be hiding? Thanks

This is a picture of the front seatbelt mount. What if anything is supposed to be covering the belt where it mounts at the floor. Some photos I've seen show a plastic sleeve or in some cases a retractor. If anybody has a picture of the cover I'd appreciate seeing it. If it matters this was...

Have a pair of these that I just took off my 66. They were welded on and the in/outlet tubes are about 1/2 in shorter now after cutting off. Good shape no dents. I removed them because I HATED the sound.... I'm near Flint Michigan and these will be local pick up only no shipping. If anybody...

Did the seatbelts where they're bolted to the floor pan have the decorative plastic covers over the bolts in 1966? Thanks Dave

I believe I saw a thread here about someone with a shop that did belts. I think it was a woman.....? Been searching and now I can't find the thread? Thanks Dave

According to the FSM the ignition switch shows a IGN 2 terminal on it with it's wire going to the ballast resistors coil side. I'm guessing this is to supply a full 12 volts when cranking the engine??? Some where back in time this brown wire was moved to the other side of the ballast resistor...

Have a 66 Belvedere "driver" that's got a bit of a growl from rear axle bearings and the right side has a slight leak. Any good reason not to ditch the stock setup and switch to something like this...

Hi all, Have a 66 Belvedere 273 V8 auto. Previous owner spent some money on a nice full dual exhaust using Flowmasters ( unknown at this point which ones ). Anyway, the droning sounds at what's basically everyday driving speeds is very unpleasant to my ears. Before I cut em off and redo the...

Hi Guy's, Looking to purchase a 7000-8000 pound lift, seems everybody and their neighbors, and maybe even the neighbors dogs build lifts. Been reading a lot about them. Thinking I can get something pretty good in the $4500 range....any thoughts? Thanks Dave

I've been looking for the typical grey plaid trunk mat for a 4 door 66 Belvedere II.....no luck. I've pretty much googled out. Any ideas? Thanks Dave

Hi guys...first post. Been reading for a while and have not found an answer to my carpet question. Dealing with a 1966 Belvedere 4 door driver. I've requested and received carpet samples from a few sources but they don't match the original carpet. The actual size or diameter of the individual...