Search results for query: *

I fixed one with a small nail some solder and flux.

Less headache. https://www.classicindustries.com/product/1967/dodge/coronet/parts/mb2498.html

What you need to know about those universal kits. Most of them are based off of a GM car and parts. Turn signal is based off of a GM harness you have to re pin or convert to your turn signal switch and harness. Pain in the ***. Ignition switch based off of GM switch. This isn't too bad but...

I would advise not to go with painless or any of the so called universal kits. M&H is plug and play and exactly what your car needs. I wired a car with a painless type harness. Its now in a plastic bag in the garage. I replaced it with the complete setup from M&H and it took me 2 days. vs 2...

Voltage regulator problems? Or possibly the Voltage limiter on the back side of the cluster. But it would have to be a weird short for the limiter to put out 12 volts. Should be 5 volts fluctuating.

My older dakota would run like **** for about 10 minutes until it relearned after a dead battery.

To make it easier. You have an engine harness plug. You have a forward light harness plug and the 3rd is just for the wiper motor I do believe. So its not that complicated.

If you look at the connectors in the schematic you can see they have letters that match So what you are looking at is the plug in side of both. As if you had the connector in your hands and looking into the pins.

And you can drive it after China attacks with an EMP...

Ok since you now know the make of the alternator there is a recent issue with it. It has been working with no issues for a while. Now the fld brush was poking out and I could see that it was not riding on the copper ring. I took it out and repaired it just to see if it would charge. I...

Simple answer 2000 Dodge Dakota 5.9 Starter.

https://sublimeparts.com/collections/all

Pink wire on the switch is 12 volts when you press the brake it sends 12v to the white wire. Download the schematics for your car here. https://www.mymopar.com/downloads/wiringdiagrams/1969Wiring.zip ChargerA and ChargerB are the schematics you will look for it pretty much has all Mopars for...

Under cranking do you have an RPM signal on the Sniper hand held? If there is no RPM signal on the handheld its not going to start. If your Tach shows RPMs that one thing but the Sniper handheld needs to see an RPM signal.

I was doing a side job yesterday. A lady was complaining about her flood lights not working. Well, either squirrels or mice got to the wiring.. Notice the wire being bare all 3 strands up into the soffit. This house was built in the 90's so not so sure soy wiring is the culprit. I think they...

These are cool but could use some kind of diffuser inside so they don't look so LED-ish. https://digi-tails.com/1969-70-charger-2-panel-sequential-led-taillight-kit

Do yo have the Shop manual for the car? mymopar.com This is a link to the Shop Manual they did not have 1968 in the list for dodge but the 69 manual should get you through most of it. https://www.mymopar.com/downloads/servicemanuals/1969_Charger_Coronet_Dart_Service_Manual.zip Here is the...

Driver side kick panel there is a plug that goes to the back of the car. Check that. All of the rear of the car is fed through that connector.