Search results for query: *

khryslerkid It's a 64

Big shout out to 71RRHI for sending me the instructions. Now I see how to plug'n'play this harness.

Mahalo !

I purchased the headlight relay system from @Crackedback a while back for a 1964 Polara and am just getting around to installing it. I've read in other posts that instructions were included however I can not locate them. I tried messaging him directly but his inbox is full. Would anyone be...

I ordered a nice new package tray from Classic Industries. The pre-punched holes for the two attachment clips are in the wrong spot which isn't a big deal. My big question is do I need to install the tray before or after I install the rear glass?

Has anyone ordered a front brake line set from Inline Tube that actually fits? I ordered a compete set of fuel & brakes lines. The fuel & rear brakes lines were PERFECT and easy to install. The front break lines are not even close to fitting. In the drawing on their website it shows the brake...

I was wondering if there is a decent quality AM/FM after market replacement radio for the 64 Polara that fits the dash frame reasonably well?

Thanks for all the quick replies. Barry ... I will definitely speedway. From what I understand the 64-65 couplers are unique and kits are no longer available. I have contacted Joe Suchy & Mancini.

I was hoping to be able to reuse the steering column on my 64 Polara but coupler is just shot. I also know that rebuild parts are non-existent. I would like to keep the original steering column and I am hoping there is a simple solution like using a different coupler. Please help! Thanks ...

Thanks ... I saw the dimples and will drill those holes when the car gets back.

There is definitely a twist to the upper column support. The car is for paint and as soon as I get it back I will get the pedals in first and see what happens. Thanks!

I purchased a 4-speed pedal setup for my 64 Polara a long time ago and I am just getting ready to install it. I started by getting it cleaned up and painted but when I started to examine it it a little more closely I realized that I may not have the correct assembly. I appears as though the...

Fought a similar problem once a long long time ago. Finally I ran into an "old" guy and he told be to check the coolant for the presence of hydro carbons. Turns out I had a head bolt that was bottoming out in the block and allowed combustion gases into the coolant. It's a cheap test ....

Mark ... I put a Vintage Air unit into my old 71 Datsun SW ... you should have no issue getting one to fit in your 62. Of course there will always be little issues to overcome. I would remove the heater box as most units have the heater built into them. Also, I have a V/A Super Cooler mock up...

Thanks Guys ... I appreciate the advise and suggestions. Mark ... I appreciate your offer to drive up but please stay safe down in Yuma ... I'm going to take all of the advise above and get creative. There are a few spot welds and originally it as covered with seam sealer which I can use to...

I need help with the floor pan fitment on my 64. I have it in place and it fits very well everywhere except for where the tunnel meets the rear floor pan. I have tech screws in there put still can not get it to align very well. The gap is anywhere between 1/4 & 3/8. Any suggestions would be...

Polara & Polara 500 panels are different. The only place I have been able to find Non-500 replacements is SMS Fabrics in Oregon. You ship them there and hopefully before you die they will send them back. They ain't cheap and I have not bit the bullet yet but they are the only source I am aware...

Here is a link for the inner fenders ... https://www.c2cfabrication.com/collections/all/plymouth+fury+1964