Search results for query: *

With the shipping 36.00

Lol

Hi everyone over the summer I rebuilt the trans in 67 GTX the original intermediate band was a solid band I wanted to keep after much research finding another was a little tough so I found Alabama band they were great quick turn around very reasonable and will install whatever lining you wish on...

Ok you are right 66 I keep forgetting that I do have one around and what a great source of info it really is I never thought that would be there about driveshafts but there it was looking me in the face lol low and behold I measured my shaft and indeed it is correct as far as damper they were...

More than likely a new one will be made I was hoping the one in there was correct to work off of without measuring lol

Thanks guys

Hello everyone I have been working on my car for quite some time and have always come across some incorrect part from time to time I need to know if the original driveshaft comes with the damper on the front yoke 440 auto I will be sending the shaft out possibly building a new one but would like...

I forgot I had another hp trans sitting in the garage I may overhaul that one and swap it out do you guys use the original sprags over or replace it thanks

I went out and adjusted the band this morning and for now it shifts fine but deep down inside I fear the band is worn I will drive it for the summer unless it fails prior to then once the hibernation time comes I will overhaul it with the red alto kit and install a shift kit as well thanks for...

That is obvious like I said it was worst case scenario a full diag needs to be done but as we all know things like this do not end well at times so before I drop the pan for a full blown inspection just wanted to know if that could be done I did not want to tie the car up I wanted to keep...

I took my car out yesterday and lost 2nd gear in D or manual 2 according to the apply chart it would be the kick down band no I did not remove the pan just yet to look around I was assuming worst case and trying to cheat it is the beginning of the season and did not want to down the car I just...

Hello everyone can a kick down band be replaced in the car thanks

We used to call the ford stuff butt juice that stuff stinks I worked for Lincoln Mercury as a tech for 26 years Also if you check with Dr Diff he only uses ford additive

I do not think you have enough friction modifier sounds like clutches are hanging up use the ford stuff I do not think the weight is the issue just suck a little out and add the bottle

Aviation on all the paper gaskets nothing on the oil pan with the exception of a small amount of RTV on corners of the oil pan or where it mates to timing cover etc nice clean neat professional job thermostat gasket as well with aviation

Aviation sealer for most of those gaskets

They weigh more than the original pistons

Good for you tear it up looks great sounds great

spend money on a good machinist that knows mopars that will save you money good pistons no trw and balance everything you will be fine

check fuel pressure make sure supply line at the tank is not cracked