Search results for query: *

Hello! Im going to put together a 426 and took some measurements of the crankshaft today since the bearings arent marked with anything. I used a newly calibrated micrometer, and this is what i came up with, this is the average of many measurements. Main journals, (1 being closest to front of...

Hello. What yoke does the 8 3/4 axle on a 1964 polara use? Its a factory 426 street wedge/4 speed car if that matters. I have an empty housing im going to set up as a spare with a more aggresive gearing, and i would like to order parts to it now. The car is garaged 14 miles away so i would...

Hello. Im going to pull my diff to swap out the gears in my Polara, and im thinking about replacing my old cone type SureGrip with another carrier, but im not sure what to get. It has a mild 505 Stroker with 589hp and 615lb/ft, 4 speed manual. Are the Detroit Truetrac any good for the street...

Hi guys. The 505 stroker in my Polara is built for running e85 and boost, it makes 589 horsepower and 615 foot pounds of torque right now naturally aspirated. Im not looking for anything crazy, maybe 800hp, so im thinking either a paxton supercharger or a turbo running low boost. Anyway, as i...

What oil do you recommend for a cone type sure grip?

Hello! I have installed a new engine in my Polara wich is a 505 stroker rb with a edelbrock Victor intake. So now the carburetor sits much higher and the stock throttle cable is too short. I made a temporary extension that sort of works but i need to replace the cable and do it properly, i dont...

Hello! I just took my third member out of my 64 Polara to install a locker but I noticed the carrier bearings (I think that's what they're called) are different on the old open differential and the new locker. The previous owner mentioned something about either the complete rear axle or the...

Hello. Im pulling my differential to install a limited slip, and also maybe put another gear set in there. The engine is a 505 Stroker dynoed to 587 horsepower and 850 Nm (627 lb-fts) with a A833 4-speed behind it and it sits in a 1964 Dodge Polara 2 door. And it sits on 25 inch tall tires...

Im lifting the engine in my 64 Polara and it refuses to let go of the transmission. I have them seperated almost an inch but more than that is impossible. Could the input shaft be siezed by rust to the clutch? Does anyone have a good tip for this or should i just try and remove the pressure...

Hello! Im trying to degree the camshaft in My 426 and about to loose My mind. I understand its not really possible to help over a forum but maybe someone has experienced similar issues and can give me some tip on what im doing wrong. The cam is a Hughes Whiplash, installed centerline should be...

Hello. I have a 426 Wedge with a 4 speed in a 64 Polara. It has Edelbrock 75cc heads, harland sharp rockers, edelbrock intake, an FST 750 carb, MSD ignition, full lenght headers with dual 3" exhaust and 4.10 gears in the back. The bottom end is currently stock. Im looking for a good...

Hello! How do i tell the difference between the house/cases that the 8 3/4 axle has? I have a 64 Polara but i know the axle is from a newer car.

Hello! My name is Victor and i am from sweden, i just bought a 1964 Dodge Polara with a 426 Street Wedge and a 4 speed. The car runs strong but i feel like i would like some more power, as well as swapping out the rear gears. Does anyone have a good recipe for a good street engine? Like heads...