Search results for query: *

I don't know enough about these A833 transmissions, so I'm asking the question. How do I calculate or find out what size speedometer Pinion Tooth size I need to buy for my A833 transmission? I have a 67 A833 trans, 18 spline installed on my 426 Hemi with a stock Dana 60 rear end (3:54). I looked...

I need to transfer a speedometer pinion from one A833 trans to another. I removed the bolt and retainer. The trans is out of the car and I have on the bench. The service manual says to remove the pinion with the cable attached to it and work it out. Well my cable is in the car. THe pinion is...

I came across this video on youtube and watched it over the last 2 days. I wanted to find a video that would give me an insight as to how to change the bearings in a A833 18 spline transmission. I found this to be very informative, with "simple" tools and a detailed approach. Now this guy has...

I want to know what brand and type trans fluid is recommended for my 67 A-833 transmission. It has been sitting for awhile and I though I'd change the fluid before I put back onto my engine to install in the car. Thanks in advance.

I have seen different versions of the heat tube finish on 66-67 Hemi's: both are not painted or the outlet tube is bare and the inlet tube is painted or both painted, see photos. Also, the exhaust header is usually cast iron grey but I have seen some that are painted black, again see the photo...

I am looking to buy a oil pump priming shaft. I found the Genuine Mopar P4286800 Oil Pump Priming Shaft for $16.16 and the Moroso #62250 oil pump priming shaft for Chrysler for $16.79 , both on Amazon. Has anyone used one of these tools to turn the oil pump in your 7.0 Hemi 426? I have my...

I purchased my 67 Charger with the 426 engine on the stand (was rebuilt). I have been working on my car to freshen it up. Once I get ready to re-install the engine, I have spoken with a few Hemi Owners that recommend removing the K member, attached the engine and trans to the K member and then...