Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Car is a 68 Charger with factory 3 speed wiper motor. The wipers have not been operated for at least 20 years, however, I had the motor rebuilt (Jules did the work) before I reinstalled on the car many years ago. Currently dash is out to facilitate other maintenance so I thought this would be a...
The brake lights, turn signals (left/right forward/aft), and flasher are not working on 68 Charger. Everything else works as it should. Is there a common denominator between these three systems? All the obvious stuff checked good: bulbs, fuse, connections, etc. The dash is not installed with the...
I have a 68 Charger. Need an ignition switch. Switch on left is what came out of car and switch on right is new one. Besides the difference in terminals the bezel thread pitch is also different. Is the new switch for 69 and above or is this the substitute switch for the correct part?
Ordered a new ignition switch for 68 Charger, however the trreads on the new switch don't match the bezel. The threads on the bezel are course and the new switch is fine. What gives? Did I get the wrong switch? Switch came from Vans
Rewiring new fuel pump (Walbro 255) I want to use heat shrink on the connectors that attach to the end of the fuel pump harness. I use MSD duel wall, tube set with adhesive heat shrink. It is made of polyolefin. The connectors attach at the top of the fuel pump mount plate so they will not...
I have a lot of primary wire in different gauges. Over the years the manufacture tags have gone missing. Is there an easy and reliable method to determine what gauge the wire is? How do you accurately differentiate say between 12-14 gauge? 16-18 gauge? 20-22 gauge? I have wire between 8 and 22...
I'm installing sniper system in 68 Charger. Using sniper control box and coil. Where did you mount your control box and coil? There are not many places to mount these in this car. Just curious on what other people have done. Pics appreciated. Thanks
I have a new connector for engine wire harness. The plastic piece that attaches to bulkhead connector. I'm reinserting the wires that came from the old connector. Is there a correct orientation when inserting the terminals into the connector? There are two tabs at the aft end of the connector...
I need to replace the plastic terminal connector for engine wiring harness in 68 Charger. I have a new plastic connector. On the old connector there's a gasket of some sort that goes inside the connector and wraps around all the terminals. The new connector does not have this. The gasket has 8...
I’m about to install Super Sniper FI, Hyperspark distributer, Holley ECU and coil. In addition I am going with a one wire alternator rated at 100 amps. Stock ignition, ballast, and voltage regulator will be eliminated. A few caveats:
Amp gauge is disconnected.
The stock alternator wire...