Search results for query: *

It looks like the 440 in my 68 coronet RT takes about 18 quarts of coolant. Can anyone tell me approximately how much of that coolant is in the engine block? Also, if the two black drain plugs are polled does that drain the block almost completely?

Driving up Gratiot Avenue, I went to shift and the clutch pedal went down to the floor with no resistance at all. I threw the trans into neutral, quickly got over to the right hand lane, and had just enough momentum to turn into a driveway. I don’t know if this was a sign, but it was the...

1968 440 stock with mild cam. What would be the most likely cause of a backfire upon hard acceleration from a 30 - 40 mph rolling start?

What was the redline for a 1968 440 4bbl 375 HP motor as defined by the company? I notice that it seems each Tic-Toc-Tach has a 5000 RPM redline. Does that mean that all 440's, 383's, and Hemis had the same redline? Were factory installed tachometers just eye candy? Has anyone ever compared one...

Any one ever seen a clutch disc come apart like this? The tore up side was against the pressure plate.

Mostly stock 440. Bored 30 over, 906 heads, mild cam, dual points distributor, Carter avs carb. Engine starts easily with timing greater than 15' BTDC, has a stutter at idle speed. Cannot get the timing to TDC before it stalls. Dwell at 35', book says 37 -40. Car has not been on the road since...

1968 Coronet RT. Got the z bar and all clutch linkages installed today. Car is not in running order yet. There is an over-center spring that I have not put in. When in this spring will pull on the clutch pedal toward the firewall. When installing a modern day clutch is this spring needed? Isn't...

Does the bracket for the carb throttle return spring attach to this hole in the head, or does it go under the first intake bolt? Or is that hole in the head for the battery ground wire?

Just got the engine and trans installed. After I bolted on the shifter and shifted through the gears, the shifter is hitting the dash in reverse and first, and almost in third. I am not positive, but I think this style shifter was OEM in a 68 RT. Is there some linkage or other kind of adjustment...

440, fresh rebuild. With the engine at a 45' angle, getting ready to put it in, after a few minutes oil started seeping in the rear. Is this normal?

Does this flange face the front or rear of the car? 1968 coronet 4 speed.

1968 Coronet 1. What weight gear lube is recommended? 2. What is the approximate capacity of an A833?

68 Coronet. Converting to a 4 speed. I have to buy all the bolts for flywheel, clutch, bellhousing, and starter. What was the reason for the stud and bolt configuration for the starter? For the stud to orient the starter and make it easier to get the bolt started? Can I just use 2 bolts instead...

1968 Coronet - stock 440 - stock 4 speed. What is the best procedure for installing engine and trans without specialty tools (like a trans jack) in the backyard, trans from bottom and engine from top. My thoughts were trans with bell housing attached and driveshaft and then something under the...

Can someone tell me which of these pickups is correct for a 440 with a 402 oil pan? Thanks in advance, Mike

Which way does this seal go? I think picture 2, but not positive.