Search results for query: *

just wondering if anyone had any input on this. I spoke to two different guys at strange engineering about a driveshaft. yesterday the guy told me a 3" was what I needed as I was keeping it under 7k rpm well today I called to place the order and the guy on the phone said I need a 3.5 to prevent...

I'm upgrading from 5/16 stock stuff, should I go with 1/2"? They make a sending unit in 1/2" but I can't seem to find pre bent lines in 1/2". So I'd probably bend my own. I'm just wondering if its needed, overkill or what? I'm running a mechanical Race pump 2000 which free flows up to 450gph @...

I know this has probably been asked quite a bit. But I am just curious I have decided I should run a motor plate because my 440 is bored .060 over and I don't want to risk any extra damage to the thin sidewalls or distortion... So my question is there a preference for plate? I will be running an...

I was reading my 2013 NHRA rule book and if I understand correctly if my car retains the original dash (unaltered), firewall, and floor which it does. I am not required to install a roll cage to run as low as 10.0 just need a 5 point roll bar? So if I were to buy an eight point kit I would not...

Hey guys, I was mocking up my bolt on subframe connectors and from the instructions that came with them it said to raise the car off the ground so the car is leveled, or something along those lines, and I was just wondering would that be much different from installing it on the ground? I...

Need to pick out a shifter for my new reverse manual tranny. I'm just wondering which shifters you prefer? ~Nick

Picked up my new engine and trans last night. Just a little street 498 :)

So I'm building a 383 for my street/strip 69' roadrunner clone and I'm just wondering where to go from here. It's a fresh 68' 383HP, forged crank, .030 KB flat top, 906 heads. I'm planning on the edlebrock RPM intake and some 1 7/8 headers. What else should I do to see 400-450hp? :headbang...

So uh yeah i might get killed but i was wondering what you guys think about them old vw beetles at the track? I've seen some run like bats out of hell and i though there cool (maybe a future project of mine) since you wouldn't expect these bugs at the track let alone running as fast as they do...

Hey guys, I know i asked this awhile ago but i'm just unsure since it's kind of a big decision. I love drag racing (Never actually raced, yet) But me and my dad just aren't sure which way to go. My clone is a small block so do i drop a 360 in, stroke,bore,add power outers and build it up to...