Search results for query: *

Does the thrust pin in the center of the differential need to come out when using green bearings?

What do the experts have to say?

My driveshaft angle is 2 1/2 degrees. Placing the degree tool on the U joint mount, the rear end is pointing downward 1/2 degree. What size shim do I need to place on top of the springs? 1969 Barracuda. Thanks. :thumbsup:

Can anyone tell me what transmission this is? Thanks!

There must be some here who have installed it. Real world opinions appreciated. Also, thoughts on this alternative "shortie" system.... https://smrtrans.tripod.com/smrtransmissionsintro/id33.html

The cam in my 66 Belvedere is the infamous "3/4 race cam", whatever that is. Being an automatic, the idle is about 1,200 & when you drop it in gear, it drops down to about 600 & barely wants to run. Not to mention that it produces no vacuum at 600 rpm for the power brakes. So. my intention is to...

Has anyone ever seen anything like this inside the coils of a 66 Hemi oil pump? If so, what is the purpose?

Does anyone here spray the head gaskets with anything before bolting them to the block? Felpro gaskets with the blue coating.

I've had a couple that have worn, but who else has been having trouble with them wearing? What do youz guys attribute it to; the rod being made of Chinesium, the camshaft, or using oil with no zinc? I just bought a Comp Cams hardened one. https://www.summitracing.com/parts/cca-4626 Thoughts?

Plastic with molded in gasket. Just curious how they hold up for leakage.

Who would be a good source for a stock 440 cam & lifter package? Thanks!

Asking for a friend... What does the '3' signify on this 1970 440 engine? Thanks!

Is it possible to get all of the oil out of the rear with a suction gun? Thanks

I've been doing a some P/M on my 69 Road Runner survivor over the winter & while the radiator was out, I figured that I'd pull the water pump, balancer & timing cover off to replace the factory timing gears and chain. Of concern to me was the plastic coated camshaft gear. In spite of the car's...

Were these used on HP 440's as well as 383's & what year did they start using them? Thanks! :thumbsup:

Did 1969 383 HP engines come with a windage tray?

Is there a way to identify a Hemi 4 speed that's installed in the car; casting numbers, etc.?

Once there is zero play, how much should the adjusters be turned in?

I forget, concave cup towards the bolt head, or towards the camshaft?

Looking to replace the lumpy camshaft in my 440 with a stock camshaft. Mancini has a Comp Cam kit for $252.00 while the MP kit is a hundred thirty bucks more. Thoughts on which to go with?