jenkins71
Well-Known Member
I think I just pryed gently and slowly with my bare fingers.
Last edited:
Yes, I use 0.23 when I am doing sheet metal butt welds. Use the tack method like photon440 says - it takes forever, but its the way to go.Thanks Scott, I really appreciate the encouraging words. It really, really helps!
I'm gonna try to get in the garage tomorrow and do some more practice butt welds, using some extra scrap i have from my old roof skin. That way I'll be able to figure out the right heat/wire speed combo. You guys think .023" wire would be good for this? And, any more advise on a butt weld of this length?
Those are the ones I have been using. They seem to work OK.I was planning on using the little square butt-weld clamps that have a wing nut on the top. They leave a thin gap--would that be ok?