So the thing I am asking is the yoke universal bearing bigger on the 489 . If so is their a yoke I can buy so I can run the smaller bearing like the 471 run's. Not doing this just yet but maybe in the next year or so.
471 to a 489
- Thread starter blue69runner
- Start date
33 IMP
Well-Known Member
- Local time
- 6:52 PM
- Joined
- Dec 21, 2017
- Messages
- 14,525
- Reaction score
- 24,722
- Location
- taxifornia,soon 2b Arizona.
There are basically four rear-end yokes. Big u-joint, fine and coarse pinion spline, and small u-joint fine and coarse spline. They all interchange if the splines match, 741,742, 489, all use the same size.
There are also billet steel yokes for the bigger 1350 u-joint. You might need that with 500+hp, and a stick or transbrake, and slicks.
(and your title should be 741, not 471. 471s and 489s are usually stroker big blocks.)
There are also billet steel yokes for the bigger 1350 u-joint. You might need that with 500+hp, and a stick or transbrake, and slicks.
(and your title should be 741, not 471. 471s and 489s are usually stroker big blocks.)
59pwrwgn
Well-Known Member
There is a conversion joint that allows you to use a drive shaft /yoke combination. Where one is a 7260 joint and the other is the 7290.. If that is what you are trying to do. Joint 2-0527 ??
Dam finger hit the wrong number. Yes you are right on. I will probably need to change the one on the drive shaft. Will check it out soon. Want to put that sure grip in. Thanks guy's. Blue.
Similar threads
