69 Superbee Hemi Orange = Driveshaft

[Rustymopar]

So I did a little playing around with the timing and carb. I got it running the best its run since
the build was complete last summer.
So I was feeling like a tough guy and dumped the clutch and snapped the driveshaft up close to the
trans.

What is a good strong balanced drive shaft - factory length but stronger?

Any links appreciated.

- - - Updated - - -

So I did a little playing around with the timing and carb. I got it running the best its run since
the build was complete last summer.
So I was feeling like a tough guy and dumped the clutch and snapped the driveshaft up close to the
trans.

What is a good strong balanced drive shaft - factory length but stronger?

Any links appreciated.

Actually its just the Yoke and U joint. Is there a tougher one then stock out there?

- - - Updated - - -

And lastly - a factory 4 speed trans (A833) for a B body had a 25 spline front yoke? correct?

 

[Grabinov911]

Inland Empire Driveline Services. I just had them do one for me.

http://www.iedls.com

I wrote about it here:

http://www.forbbodiesonly.com/moparforum/showthread.php?36174-80-Grit!/page6

 

[Lionized]

You could also look into carbon fiber.

 

[dvw]

Dyno-tech in Michigan, free shipping, great quality. Their steel shaft will be more than enough. I own 3 of them, two steel, one aluminum. The aluminum one holds up behind my 572 64 Belvedere, 1.25, 9.04 @
151
Doug

 

[Photon440]

So I did a little playing around with the timing and carb. I got it running the best its run since
the build was complete last summer.
So I was feeling like a tough guy and dumped the clutch and snapped the driveshaft up close to the
trans.

What is a good strong balanced drive shaft - factory length but stronger?

Any links appreciated.

- - - Updated - - -





Actually its just the Yoke and U joint. Is there a tougher one then stock out there?

- - - Updated - - -

And lastly - a factory 4 speed trans (A833) for a B body had a 25 spline front yoke? correct?

Input splines should be 23 for the regular 833 and 18 for the hemi version. Output splines for your year should be 30, same as the 727.