Satellite72
Well-Known Member
I've got a question for any of you guys that have installed a small block Air-Gap Intake and carb. I finally installed my Air-Gap intake and Edelbrock 600cfm carb this weekend and have run into a slight conversion problem. The engine was originally a 318 2bbl car, and I'm finding that the 2bbl linkage won't fit the Air-Gap correctly. The linkage bracket is to shallow to be bolted up to the intake and the Edelbrock is of coarse much wider and higher up than the 2bbl. I'm sure several of you probably have this set-up, so what linkage would work for this application?.... would a stock small block 4bbl linkage work? Below are some pics of where I left off yesterday (the wife took the good camera for the weekend so they are crappy camera phone pics). Note that the one showing the linkage is not bolted but just sitting on the intake. Any help or direction would be great fellas... Thanks!