Coronet_Arch
Well-Known Member
Today, I began putting back together the Atlas metal lathe I purchased a while ago. I had to disassemble it to get it out of the basement from where I bought it. The motor and the wiring needed replaced. It had a Maytag motor on it and the insulation of the wiring was falling off. The original switch had been removed and replaced with a toggle switch mounted to the board the lathe is mounted to.
The following error occurred:
Security error occurred. Please refresh the page and try again.
I can't post any pictures, I get the above error every time.
The following error occurred:
Security error occurred. Please refresh the page and try again.
I can't post any pictures, I get the above error every time.