- Local time
- 7:15 PM
- Joined
- Feb 22, 2021
- Messages
- 2,774
- Reaction score
- 5,485
- Location
- Roswell, New Mexico
Hey all,
During the mock-up of the steering
shaft, I had to cut out some floorboard
and firewall sheetmetal. This is on a
1940 Plymouth pickup with a 440
stuffed in where a flat head six used to
reside. The engine is set back into the
firewall 2.50 inches. Where the firewall
and floorboard join, just so happens
that's where the steering shaft is.
Any ideas or recommendations as to
how I can seal this up?
During the mock-up of the steering
shaft, I had to cut out some floorboard
and firewall sheetmetal. This is on a
1940 Plymouth pickup with a 440
stuffed in where a flat head six used to
reside. The engine is set back into the
firewall 2.50 inches. Where the firewall
and floorboard join, just so happens
that's where the steering shaft is.
Any ideas or recommendations as to
how I can seal this up?