full floating wrist pins on cast rods with no bushing on the small end?? should i pull it back apart and have it done?? really bugging me.
I do steel on steel in my shop with BBM, a beveled 1/8" hole on the top and I set them at about .0012 to .0013" clearance, not a problem and as stated there are no cast BBM rods. After setup it takes me maybe 5 to 10 minutes a rod to do.full floating wrist pins on cast rods with no bushing on the small end?? should i pull it back apart and have it done?? really bugging me.