Hood Pin Location - 69 RR

[Lamadogg]

Looking to install hood pins on 1969 RR. Not lift-off hood - standard steel with hinges. Does anyone have factory specs on correct hole placement? Obviously, will not get a second chance so want to get it right. Will purchase from Year One and plan to get 25" tethers based on ther recommendation, part #A010025S. Also, where do the studs install as well as tether attachment under the hood. Photos appreciated.
Thx.

 

[68GTX4SPEED]

http://a12mopar.com/yabb/YaBB.pl?num=1198528150/13#13

 

[Lamadogg]

Thank you very much. Hope this works!!

:hello2:

http://a12mopar.com/yabb/YaBB.pl?num=1198528150/13#13

 

[Lamadogg]

Thanks for link to 'Lift-off' forum. Though it took a while, I finally installed the hood pins. Rather than use the existing inboard radiator support bolt, I chose to use the A12 hole location and drilled the holes. I must have measure a dozen times before drilling the top hood holes! I feel the location closer to the front edge of the hood and looks better. Thanks again. They look great. See photo.