Polara383500
Well-Known Member
Looking for gasket that fit the HP’s better the remflex ones doesn’t seem to cover the HP’s completely.
High Performance manifoldAre you abbreviating headpipe as HP?
I have those and they don’t cover the whole manifoldsBut they are readily available from any jobber..
View attachment 1110732 View attachment 1110733 View attachment 1110734
Feedback I'm getting says the Hemi didn't use them either. They were attached to the heads with bolts and the conical washers as some small blocks used. I'm having my Hemi exhaust manifolds surfaced at present and going to not use gaskets. Also my 440 67 GTX survivor has no gaskets and has never been apart and I reassembled the 440 in my Superbird without gaskets because the exhaust manifolds were original to the car. No exhaust leaks at present.factory never used gaskets, except for hemi and max wedge.
I just bought 10 NOS head pipe gaskets from @rbkt65 because they better than anything you can find in a parts store.Are you abbreviating headpipe as HP?
It’s says that it doesn’t fit my yr but I think they all the same from.CHRYSLER Fel-Pro MS90425 Fel-Pro Exhaust Manifold Gaskets | Summit Racing
Protects the valve cover gasket itself and valve cover paint from the extreme heat on the HP Manifolds
They came on the RV ,sIt’s says that it doesn’t fit my yr but I think they all the same from.
Just a little trivia here,,,,, RTV= room temperature vulcanization.As mentioned factory did not use gaskets on most exhaust manifolds. I have had great luck using high temp RTV. A bead around each port and let it set up 30 minuets, install snug but not tight, let sit up overnight, then tighten down. As long as your surfaces are square works great.
View attachment 1110991
I have had great luck using high temp RTV. A bead around each port and let it set up 30 minuets, install snug but not tight, let sit up overnight, then tighten down. As long as your surfaces are square works great.
CHRYSLER Fel-Pro MS90425 Fel-Pro Exhaust Manifold Gaskets | Summit Racing
Protects the valve cover gasket itself and valve cover paint from the extreme heat on the HP Manifolds