Mancini distributor and MSD 6AL question

[sixsixvette]

I have a 69 GTX that a purchased as an incomplete project. The 440 has been professionally rebuilt by previous owner and remains pretty stock, no performance mods from what I was told. The project came with many parts to complete the car to include a Mancini Pro Billet distributor and an MSD 6AL box. Knowing that I already have these items in hand, are they a good option to install? Or should I be looking at something else as an alternative? Is there any info out there on exactly how to wire up these into my stock GTX? Obviously some significant changes to factory ignition items, so I figure someone has gone this route and may have some knowledge I could use. I did search the forums and not finding much on actually wiring in the 6AL box.

 

[Crackedback]

The destruction that are in the box might be a good start...

Only deal is that you have to tie the wires that feed the ballast resistor together so the box is switched on in both start and run key modes. Some leave the balast and run a single wire to the msd small red wire.

The MSD and distributor are fine if you don't care about originality. Some will bitch about the lack of vacuum advance, it helps fuel economy.
If the distributor uses a bushing, put the 18* on it and it should run pretty decent with 16 initial and 34 total as a starting point.

Just my 2 cents

 

[gkent]

Run it !! You can hide the MSD box under the dashbehind the ash tray but no point if using a non stock distributor. But I'd go with both of those any day of the week.

The distributor is probably "plug and play" with the MSD. Instructions are a good place to start! Available on line if you don't have them. Google is your buddy !!