Coronet67guy
Well-Known Member
Hey guys. So I'm swapping out the original intake on my P code 400HP motor in my 74 Charger with the Eddy 2186. A lot of different opinions on the proper way to do this and want it leak free! Here's what I have -
New valley pan, and the four paper gaskets that came with that pan.
Edelbrock 7225 gaskets, bought before I knew the valley pan would have gaskets, and plus these were the recommended gaskets for the intake. Just two of these of course.
Ultra black gasket maker, for the front and rear seals.
Super high tack gasket sealant - seen people use this to hold gaskets in place so grabbed a tube.
Open to suggestions. Will do this tomorrow. Can I use the paper gaskets between block and valley pan and the nicer 7225 on the intake side? I've seen many that don't use any gaskets under the valley pan. Who's done this job and what worked for you?
Thanks!
![IMG_5587.jpg IMG_5587.jpg](https://www.forbbodiesonly.com/moparforum/data/attachments/872/872155-3e5b4616ca158f11c73e602c83e57ac1.jpg)
New valley pan, and the four paper gaskets that came with that pan.
Edelbrock 7225 gaskets, bought before I knew the valley pan would have gaskets, and plus these were the recommended gaskets for the intake. Just two of these of course.
Ultra black gasket maker, for the front and rear seals.
Super high tack gasket sealant - seen people use this to hold gaskets in place so grabbed a tube.
Open to suggestions. Will do this tomorrow. Can I use the paper gaskets between block and valley pan and the nicer 7225 on the intake side? I've seen many that don't use any gaskets under the valley pan. Who's done this job and what worked for you?
Thanks!
![IMG_5587.jpg IMG_5587.jpg](https://www.forbbodiesonly.com/moparforum/data/attachments/872/872155-3e5b4616ca158f11c73e602c83e57ac1.jpg)