I’m looking for some help here. I’ve searched using multiple phrases on this forum hoping to find some guidance on what type of foam or sealer to use between the fender and inner fender to simulate what was done at the factory.
Specifically, I’m referring to the sealer that squeezed out and is visible along the top horizontal edges that prevents water from getting between the panels from above and below. I tried finding a pic to show the area, but I’m not finding any good ones pointing it out.
If anyone can help with recommending a good paintable material to use and any tips for applying it would be appreciated. I’m guessing the stuff has to have a long working time to allow for someone to apply and get fender hung, aligned and bolted into position before it’s fully set up.
Thanks in advance to anyone who can help educate me on this.
Specifically, I’m referring to the sealer that squeezed out and is visible along the top horizontal edges that prevents water from getting between the panels from above and below. I tried finding a pic to show the area, but I’m not finding any good ones pointing it out.
If anyone can help with recommending a good paintable material to use and any tips for applying it would be appreciated. I’m guessing the stuff has to have a long working time to allow for someone to apply and get fender hung, aligned and bolted into position before it’s fully set up.
Thanks in advance to anyone who can help educate me on this.