Hi All, Hoping someone can help. was sanding out the evercoat finish sand primer on the car yesterday and noted that the pain had chipped off the bottom of the seam sealer at the drip rail. Pushing on it elsewhere in the drip rail channel it kept cracking and popping off. I used SEM single part seam sealer, PPG DP90 and then evercoat finish sand primers on it. I scuffed up the seam sealer pretty good. The seam sealer is pretty spongy not rock hard like the old stuff I removed. It's about 3/16" thick. I noticed when removing the masking tape and paper off the car the evercoat primer was cracking off the paper and tape - looked brittle or unbonded? Anyadvice on this issue would be appreciated. Pic for reference below. Thanks in advance!