Looking for a picture of the throttle return spring bracket for a 440 with a/c.
Thanks!
Thanks!
Picture request
- Thread starter Richard Cranium
- Start date
Seems I remember a small bracket with a loop (hole) in it for the spring, and bolted to the back of the AC compressor. I can not find in in a manual, but I will try to remember to look in my bracket drawer when I get home. If I have one, I will snap a pic. If I have two, I could offer one to you.
I know I've seen that bracket as described above.
Classic. MF204
The MF204 is for a non-ac hemi, although the small bracket might work. I looked in my stash, and didn't see it. I have a few more places to look at work, but I might not have it anymore. If I do find it, I will let you know.
My car has one, but it seems to be unusually bent & I need to see another for a comparison.
RC, which Year car? I have one on my 68. The photos above show what it looks like.
Last edited:
The one I remember bolted right to the AC compressor.... Classic MF207
Last edited:
My '68 was built in 11/67 & it looks like yours except without the tang that goes into the front bracket hole. However, my arm was pretty bent over & I do see yours is a lot straighter then mine. I'll post a picture of min e soon.
69a100
Well-Known Member
- Local time
- 3:54 AM
- Joined
- Aug 22, 2012
- Messages
- 11,455
- Reaction score
- 17,511
FWIW RC, the bracket that 68 shows is the same as on my 66-300 383 w/ac. I don't know if the heights are different then a 440? It would make sense that they are all the same as Mopar liked to use interchangeable parts when possible. Good Luck
Here's mine. Prior to this picture, it was bent at a sharp angle towards the center of the engine. Looks like I'll have to take it off and bend it straighter
Plus you are missing one spring there. There should be two (in case one breaks).
Similar threads
