Pilot bushing measurments

[anmracing]

I have a question about my tanny..... LOL!! I said tranny.... Ok that was stupid.

Anywho, pilot bearings or bushings in a 440 block, anyone out there know the overall diameter, outer diameter of the bushing I need.

Thanks in advance!!!! This place rocks!!! :headbang:

 

[ply64post]

I have a question about my tanny..... LOL!! I said tranny.... Ok that was stupid.

Anywho, pilot bearings or bushings in a 440 block, anyone out there know the overall diameter, outer diameter of the bushing I need.

Thanks in advance!!!! This place rocks!!! :headbang:

anmracing

There are 2 bushings the diameters are:
.941 napa part # 615-1026 this the standard bushing for the original standard machined cranks.
.915 napa part #615-1033 this used in the automatic cranks.
I had these on the shelf, so I'm not sure if they are still available.

Hope this will help
Jeff

 

[67 gtx cov]

need to know what tranny 18 spline or 23 in put shaft are different next forged crank or cast

 

[anmracing]

Forged crank with a 23 spline. I know the inner diameter if gonna have to change because I'm converting to a 5-speed. I just needed the o.d.

Thanks Ply64post and 67 gtx cov!!!!