greycharger
Well-Known Member
Bringing back a 1969 with 100K. Neglected and forgotten, but always cared for, so I hope a rebuild isn't needed at this time. The car is so nice and unmolested, I didn't paint the pan or valve covers, but left them original. Dropped the pan, cleaned out the sludge, new pump. When priming with a drill, I felt when it primed and I spun it for a few minutes after, but never got oil to the rockers. Does a drill not spin it fast enough to get sufficient pressure?
Next will be: pull the plugs, Marvel/Sea Foam/witches brew in the cylinders, turn it over by hand a few revolutions, let it set for a couple days, then turn it over with the starter, then fire it.
Any advice or witches brew recipe welcomed and appreciated.
Next will be: pull the plugs, Marvel/Sea Foam/witches brew in the cylinders, turn it over by hand a few revolutions, let it set for a couple days, then turn it over with the starter, then fire it.
Any advice or witches brew recipe welcomed and appreciated.