question about waterpumps

[BeatersRus]

hey fellas,im working on an old 72 400 steel crank motor,and need to replace the waterpump housing and the pump.
while perusing various sites,i noticed that there was a long snout and a short snout? option ?? but no one seems to clarify that.
mine seems to measure out at 3 inches?

from these pics and measurements can you advise what i should get?
id like alum if possible.
motor is in front of a 4 speed,so i was also looking at the higher flow pumps?
thanks for any advice you can give.

 

[Lefty71]

I thought long and short was only small blocks, but i could be wrong. All the big blocks i would think are rather short snouted.

 

[493 Mike]

hey fellas,im working on an old 72 400 steel crank motor,and need to replace the waterpump housing and the pump.
while perusing various sites,i noticed that there was a long snout and a short snout? option ?? but no one seems to clarify that.
mine seems to measure out at 3 inches?

Where did you get that information? I never heard of it.
Mike

from these pics and measurements can you advise what i should get?
id like alum if possible.
motor is in front of a 4 speed,so i was also looking at the higher flow pumps?
thanks for any advice you can give.

View attachment 1897717

View attachment 1897718

View attachment 1897719

 

[pnora]

Pumps are the same. Sounds like you are looking at Chevrolet pumps. Water Pump & Housing Packages

 

[tonysrt]

All B & RB pumps are the same size. They would use a spacer to bring fan closer to the radiator

 

[BeatersRus]

Where did you get that information? I never heard of it.
Mike

i think we were on the jegs site when that popped up.
made me scratch my head too,thanks