charger greg
Active Member
I have upgraded my engine package to the Trick Flow 270 heads and a roller cam.
So I am selling my Trick Flow 240 Cylinder heads, Trick flow track heat intake, Hughes engines stainless valley covers, Smith brothers push rods and Hughes engines cam with lifters.
These parts have one season on them, 48 runs in total and 125 street miles.
The cylinder heads have the 1.55 valve springs and are advertised for .680 lift. The heads been disassembled and cleaned.
The intake has been deep port matched by Hughes Engines , it has not been cut or milled
There are 2 valley covers that are complete with end plates and hardware they fit the Trick Flow heads very well.
The push rods are custom Smith brothers .085 wall with an overall length of 9.810, an effective length 9.665 they fit this package with 1.5 ratio Harland Sharp rocker arms.
The cam is a Hughes engines grind duration 254in / 260ex @.050. Lift is .600in / .614ex with 1.5 rockers. The lifters are Johnson EDM to provide positive oil pressure to the cam/lifter interface.
I bought all the parts listed from Hughes engines in 2024.
I prefer to sell the parts as package. My 3700lbs. car went consistent 10.70's - 10.80s with these parts on a .030 over, stock stroke 440.
I'm asking $2350.00 for every thing listed.
Greg.
So I am selling my Trick Flow 240 Cylinder heads, Trick flow track heat intake, Hughes engines stainless valley covers, Smith brothers push rods and Hughes engines cam with lifters.
These parts have one season on them, 48 runs in total and 125 street miles.
The cylinder heads have the 1.55 valve springs and are advertised for .680 lift. The heads been disassembled and cleaned.
The intake has been deep port matched by Hughes Engines , it has not been cut or milled
There are 2 valley covers that are complete with end plates and hardware they fit the Trick Flow heads very well.
The push rods are custom Smith brothers .085 wall with an overall length of 9.810, an effective length 9.665 they fit this package with 1.5 ratio Harland Sharp rocker arms.
The cam is a Hughes engines grind duration 254in / 260ex @.050. Lift is .600in / .614ex with 1.5 rockers. The lifters are Johnson EDM to provide positive oil pressure to the cam/lifter interface.
I bought all the parts listed from Hughes engines in 2024.
I prefer to sell the parts as package. My 3700lbs. car went consistent 10.70's - 10.80s with these parts on a .030 over, stock stroke 440.
I'm asking $2350.00 for every thing listed.
Greg.
