Whistling hissing air sucking

[joseph p.]

Hello to all,I got a 1968 383 with a 6 mos since rebuild of my Carter Avs 4bbl,ran perfect, started this hissing sound,too much air induction,maybe the butterflies are stuck open???,thanks for any suggestions.

 

[joseph p.]

 

[joseph p.]

1969 satellite with 383 block.

 

[khryslerkid]

First thing is your choke is a bit strong.

 

[joseph p.]

no,its been set accurately,,thanks

 

[khryslerkid]

no,its been set accurately,,thanks

Then why is it almost closed? Does it ever fully open?

 

[joseph p.]

First thing is your choke is a bit strong.

Yes I will check the choke,thanks

 

[Macdon221]

I will second the choke comment....if that engine is warm....your choke is all wrong.

For the whistling....start removing hoses 1 by one and capping the input. That will rule out any hoses. Don't forget to do the choke pull off diaphragm hose.

Did you change a base gasket?

Use a stethoscope to pinpoint the noise if the above does not work. Pay attention to the throttle shafts where they go into the carb. Place scope there.

Slightly re-tighten the carb bolts to see if a change.

 

[joseph p.]

Then why is it almost closed? Does it ever fully open?

yes it will fully open,I seen it open yesterday from the ride,still was hissing,this vid is from this morning cold start,I checked base plate bolts also,thanks again

 

[joseph p.]

I will second the choke comment....if that engine is warm....your choke is all wrong.

For the whistling....start removing hoses 1 by one and capping the input. That will rule out any hoses. Don't forget to do the choke pull off diaphragm hose.

Did you change a base gasket?

Use a stethoscope to pinpoint the noise if the above does not work. Pay attention to the throttle shafts where they go into the carb. Place scope there.

Slightly re-tighten the carb bolts to see if a change.

yes new base gasket.

 

[Macdon221]

ok well try going back to the old base gasket.

Did you make a change from 4 hole to fully open or vice versa?

 

[joseph p.]

base gasket culprit,thank you guys for the help,yes its stock 4 whole.

 

[joseph p.]

 

[ruffcut]

Pretty good. Members here fixed it and never put a hand on the car!