Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hi Everyone... just wondering if anyone has experiance with install the clutch stiffener bracket on firewall. Got a 69 clone runner that was previously converted from Auto to manual. I've read that these are helpful.
Thanks in advance.
Ok.. I'm sure this has been discussed to death....
As a result of pulling apart the instrument cluster in the dash to repair the wiper pivots, now the speedo cable is jumpy at different speeds and when is it jumpy it get really noisy. I've already reinstalled all the dash components...
Update on the dash lights.... First off... all fixed and working...
Couple things I did since the last update...
1. Cleaned up the dimmer switch which gave me the cluster light... still had no signal lights.
2. Ran a new cluster ground wire with quick disconnect to steering column...
ok, I have an update on this issue... I was hoping it was resolved by now... but.....
I have the heater fan working now... I checked fuses... there was a 20a blown which I replaced... after heater fan was working. I ran a ground wire from circuit board mounting screw to the steering column...
Hi Everyone,
I currently have a bench seat setup in my RR. The question I have is, can you install head rests into the current seat configuration? And what would be involved with making that happen ?
Thanks
G
I'll try to keep this a short but detailed as possible. I have a 69 Road Runner. I just restored my wiper pivots. I ended up going through the dash for this. I removed the lower switch panel, lower dash pad and gauge cluster. While it was out I freshened up the lower switch bezel and...
Issue seems to be resolved. I took the front wheels off last night... got at the wheel bearings and found the bearing nuts had backed off a little bit... passenger side took about 6mm to snug it up and drivers side was about 2mm. reinstated the nut cap and cotter pin.... Took it for a...