Recent content by prostockstan

We have installed all new harnesses and dash harness with new fuse box but can not seem to find the mounting location can someone help with photos or let us know where to mount it. It has one screw location on the plastic fuse box and two little plastic tabs sticking up about 1/16" of an inch...

I just finished a complete resto on a wiper motor and it did not work properly. The problem was in the switch. The one spring loaded contact was stuck from heat and hardened grease. You can disassemble the factory switch by bending the peened areas around the diameter of the switch outward and...

The 1966 The 1966 charger uses a variable speed switch not a 3spd. As you turn the knob the speed increases. I'll be glad to coach you through any problems with yours. I also do switch and motor restorations.

I have experience rebuilding these switches. The common problem is hardening grease inside the switch and over heated contact on the reverse direction portion of switch. When you turn the switch off the direction of the motor reverses to allow the wipers to stop in the down position. I rebuild...

The Gold box is not going to work on the street without excessive heating at low RPM. I tried it once and had problems. Chrome box is a better choice for street / strip.

Check your vacuum at idle in gear if automatic. Change the color coded step-up springs to the value 1/2 of what the vacuum reading is. The needles are dancing at cruising speed and causing erratic surging. You can flip open the needle covers and tighten them half open and see what the needles...

After reading articles about people having trouble assembling the steering column switch housing I thought I would give some advice. This procedure is having the complete column out of the vehicle. all parts must be removed from the column, then assemble the switch housing to the inner tube via...

Thanks for all your help on this mystery. Problems solved and switch is on the way. This site rocks!

Thanks, I did find a good used hold open switch. Should be here next week sometime. If it doesn't work I will contact you for a future yard pick. Thanks again!

Thanks again. I just replied to him.

Do you have a "Headlamp hold open" switch? Thanks, let me know!

Where can I find one of these switches. I can't find anything about them on the net. Do you have any idea who might have one of these switches. We would like it to be original. Thanks again for your help!

From what I read she did kill someone in the house she drove through.

I used Denny's for my 512" 1965 coronet. Good for 1200 HP I'm pretty sure it's thick wall aluminum.

Can someone please help me with a problem. We installed a new dash harness. There are two black wires near the headlight switch. The schematic says rotating headlight switch. Does anyone have a photo of this switch or have one for sale? Apparently a previous owner took it out because there is an...