1968 69 Dodge Charger Hood Depression Black Out Stripe Kit

The Rebel · May 14, 2021

Hey guys, bought a set from DCS and was wondering how you cut the centers out assuming you apply the sticker 1st and then cut it out on the car. I'm guessing that's how it was done by cutting an X in the area.

mrhemi · May 18, 2021

I am not understanding what you need to cut. Mine came from Pheonix Graphics and all six pieces were pre-cut to fit.

Kilrbee · May 18, 2021

Mine was from Performance Car Graphics and was the 6 pieces also.. I believe that only the stripes that ran over the marker light openings were "X" cut.

The Rebel · May 18, 2021

DCS sells them as they came from the factory back in the day. They're not pre-cut into 6 pcs but come as 1 long piece per side.

Don selleck · May 18, 2021

there rounded on the ends, x cut is if you have turn signal indicators, so you can put them in after you install the graphics

The Rebel · May 19, 2021

Don selleck said:
there rounded on the ends, x cut is if you have turn signal indicators, so you can put them in after you install the graphics

Yep I have the hood mounted turn signals.

Kilrbee · May 19, 2021

There will not be enough material to "X" cut the openings. I would cut them about 1/8" to 1/4" long on each side of the opening and install the turn signals.

The Rebel · May 19, 2021

Thanks. That's what I was thinking as well. They delivered today so I'll be installing on sat.

1968 69 Dodge Charger Hood Depression Black Out Stripe Kit

The Rebel

Well-Known Member

mrhemi

Well-Known Member

Kilrbee

Well-Known Member

The Rebel

Well-Known Member

Don selleck

FBBO Gold Member

The Rebel

Well-Known Member

Kilrbee

Well-Known Member

The Rebel

Well-Known Member

Similar threads