Search results for query: *

Does anyone know what is concourse correct for paint on these? My original appeared to be painted gloss black, including the 4 nuts that attach the master cylinder. I thought I read in a procedure/build article by David Patik on wing cars that stated this as how it was done, painted as an...

Wtb a set of 10-7-69 or close u-joint straps. I have several sets to trade. I also need one bolt and washer like in the pic. Thanks

Have you ever looked at how bad the ends are finished on these, quite the restriction. Right is factory 3/8, left is fine lines 3/8 stainless.

Mopar Performance Hemi Parts P4529336 2- heads P4529338 covers P4529879 studs P4529895 pcv valve P4529705 8- intake rockers P4529706 2-exhaust rockers 6-used exhaust rockers P4876071 4.50 bore head gaskets Set of used stainless valves $3000 plus shipping from 68108 valves

Is there a chart that has this info? On the left is a 1971 440-6 cable it is green. Center is my 1970 440-6 sbird, white with a 316 9 date code. Right is a 1971 440-6 mp cable cars with red.

Did they use 3 of the 7/8 washer head bolts, or two 7/8 on the rear and one 1-1/8 at the front.

Anybody know where these go?

Just a little hint, doing my car and do not want to mark anything up, did the outers by 4 welds on a washer and pushed them, did the shaft sleeves with 2 notches ground in the sleeves, thinned them a little with a grinder to get them hot, then pushed off with a bearing separator, whole job took...

Just a little hint, doing my car and do not want to mark anything up, did the outers by 4 welds on a washer and pushed them, did the shaft sleeves with 2 notches ground in the sleeves, thinned them a little with a grinder to get them hot, then pushed off with a bearing separator, whole job took...

Were thay bare steel or phospate, black oxide. These looked black after evaporust soak, but not sure. I have new ones but they have some type of coating, but want to get this right, and reuse these originals. Thanks.

Pic is how it came out of evaporust, should it be the dark forged look or polished up a little to make it shine, or more silver. Thanks

Is bare metal with the gray, yellow, purple rainbow haze still considered correct for a superbird. Just finished these with some old metal conversion coating and rpm. I thought I read that in a roger gibson artical or somewhere. Thanks

Did they use the 7/16 head with h stamp, or the common 3/8. The yoke is off the dana and had these on it, to late for the car

What is correct for a late 69 build 4-speed car. It came with 4 long bolts with the spinner "turned down nose", 4 thick, 4 thin washers, and 4 plain nuts, in a can. Also what is correct for the single center 5/16 mount bolt. It is nov 30 hamtramk build if that matters,Thanks.