Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I did a 4-wheel Right Stuff disc/disc conversion on my '69 Charger last fall, but the rear brakes have never seemed to brake correctly. I'm using the front/rear adjustable valve, but it has never seemed to do very much. I think the proportioning valve from Right Stuff for disc/disc...
Hello,
My 727 and/or torque converter apparently has failed on my '69 Charger with 440 engine with TTI Headers/Exhaust .... left a trail of fluid on return trip to house, and is leaking from torque converter access plate. Must have broke pump seal or cracked the housing ? Dang ! It only...
Hi,
Installing the rubber felt pieces (AS2001) into the window rear run channel on my '69 Charger, but it did not include rivets... can I use pop-rivets ? Was not sure if the window glass metal channel would interfere if I used them... thanks...
I'm installing my fenders on my '69 Charger after painting, but don't recall the bolt install & J-clips for the hood hinge.
To test, I put a new after-market J-clip in the fender where the upper-bolt on the hood hinge installs, but it seems like it adds too much thickness -- causing the fender...
Hi all..
I'm looking to drill the holes to mount the rear window SS trim clips, but not quite sure of the locations.
I went through the threads and come up with the following locations...
How does this look ? What about the lower corner clip locations -- does this look correct ...
Hi all,
Trying to install my Fitech Go EFI 4 (30001) in my '69 Charger w/440 in the timing control configuration. Using a Holley Hyperspark Hall-Effect distributor 565-306,
Seems the Holley Distributor should connect directly to the ECU on the Fitech ? The only difference is the added...
Restoring my '69 Charger from scratch... I have only the rolling chassis on the ground ( 440 engine, 727 trans, ESPO XD suspension, 8 3/4 rear-axle installed -- no doors, hood, trunk, glass, etc.. ) and wanting to measure for a new Strange U1699 3" driveshaft (1350 U-joints)
But from what...