Search results for query: *

Looking for a set of arm rests to match 63 Plymouth interior. 4 door Red please. Lost mine in a shop fire. Cheers

Hey Guys Finally getting around to re-assmbling the wagon after a long unintended break. The trim that mounts on the tailgate has a speednut in the center but there are two aligning holes top and bottom on the body and I can't seem to find what goes in there. I didn't dismantle this...

Just looking for some feedback on carpet choices. Looking for a carpet for my '63 dodge 330 wagon and ACC has quite a few. What is the easiest to install? Molded or unmolded? 80/20 or 80/20 with mass back? essex super plush? tuxedo? Also looking for some decent floor mats. Any...

I need to pull the entire dash in order to paint it. Everything else is stripped at the moment and I'm wondering if there are any tricks to removing it that I need to be aware of. Any info would be greatly appreciated.

Been trying to polish these up and not having much luck. Any suggestions would be helpful....thanks.

Just starting to put together the newly machined 440. This motor will be a wedge wanne be with the dual quad setup. I'm wondering if it would be better to break in the motor with a regular 4B intake and swap to dual later? Thanks

The car is coming home from the paint shop and I'll soon be wrenching away as I drop the new motor in. I'll be needing some good fender covers to protect the new paint. Any suggestions? Thanks

Here are some photos of the clips that held on the body trim from my 63 dodge wagon. I've seen something similar from restoration specialties but I'm wondering if there is anything like a spring clip that would work instead or if anyone has any suggestions? Thanks PS- does anybody have a...

Ok guys, Looking for some opinions. Currently building a 440 Wedge wannabe for the '63 330 wagon and have a stock oil pan that needed some modifications(dents) to clear the tie rod. The car will see light to moderate strip use and lots of street use. Thinking about a larger volume oil...

Does anyone know the trick to getting the gas tank into the tight space where it lives on a 63 wagon? ie: pulling the axle? Thanks!

Tried this thread in the 'wanted' section without any luck so I'll try it here. Looking for a non-pretzeled lower valance for a 1963 dodge 330(wagon) Here's what I have...don't want to pay to body-man for all the hours to make it straight. Thanks in advance!

Its go time on my '63 wagon and I'm looking for some material for the seats. Anyone know where I can find some NOS type material or have any good service stories to share? I'm going for a stock look. Much Appreciated! Here's what I have....looking for something close to the red panels

Hey guys, My car is in the shop for paint and body work and the saggy doors are off. I'm looking for pins and bushings that will fit. I searched some of the threads but did't get any good info. Thanks!

It was a long winter without much progress but in the last few weeks things have really come together. Big thanks to 'Dangerous' Chris Carlson and Polara Pat for all their help. Managed to get the motor off the stand and into the car. Just had our Muffler guy, Mode, put the exhaust system...

Hey Guys, I'm looking for patch panels for: right and left front between door and wheel well. right and left rear panels I've attached photos as well. I've checked this thread and I'm looking for other suggestions as well. Cheers

I guess this is where I should start... I have a healthy addiction to my canadian 63 dodge 330 wagon. It came with a canadian only 313 poly and has a plymouth interior. They did things a little differently up here back in the day. I've spent the last few years racing and picking away at the...