Search results for query: *

I am finishing the exhaust on my 69 Charger with a crate 6.4, tti headers and x-pipe. So far, so good. I also installed a Ford 9 inch rear end with a Control Freaks triangulated rear coil suspension. Also so far, so good. However, when it came to fitting mufflers, the inner control arms from the...

I'm getting to the point of putting the hood back on my 69 Charger and have to purchase the latch and primary lever mounted on the support (I do have the secondary latch mounted on the hood). Before I purchase and install the factory solution, has anyone found a more modern alternative that...

I'm looking at two different ideas for the seats in my 69 Charger. The Procar/Scat option looks good initially but it sounds like their adapters/brackets for the B-body are essentially useless. The other option I'm looking at would mounting the factory brackets/sliders and fabbing something to...

I have installed a Vintage air HVAC setup in my 69. Since these aftermarket HVAC systems do not have an 'outside air' option I am trying to decide if I should retain the factory fresh-air box under the driver's side dash. On the other hand, if I replace it with a plate that would make a...

Has anyone installed the Magnum 6 speed kit from Silver Sport Transmissions? I just started (69 Charger) and I found the SST trans crossmember holes don't line up with the factory torsion bar crossmember...they are about 1/4" off (too short). I attempted to 'squeeze' the factory crossmember...

Greetings, I am a relatively new to this forum and B Bodies in general. I recently purchased a finished (paint and body) 69 Charger shell without suspension or drivetrain. I was hoping to ask for some advice from others concerning a couple things: 1. I have decided on a tubular K front end...