Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
HI, Since I cannot find a decent used inner trunk cover for my tail lights and it appears there is no repops to be had, I am thinking of reproducing these myself. But what I need is a few nice clear photos of what they look like. If anybody on here has a correct one installed in their 66, I...
Doing a resto on the steering column and I lost the screw that holds the directional arm to the new turn signal switch I installed. I was wondering if anyone on here knew what type and size? Also, is there somebody who just sells the spring that goes inside the column joint to hold those two...
Hi, getting to my dash now. I have no radio in it. Is there a radio I can install with the bluetooth and serius to work with the EL lighting or maybe look like the EL lighting. I don't want to look for a stock radio as I prefer bluetooth and hands free phone. What has everyone here done for...
These are the clips that hold the 66 hood moulding as well as the lower grille moulding. We did them in stainless steel. I have a few sets left. They are $170.00 and shipping to you is FREE. While supplies last......
Just pulled me console front and wiring. Automatic car. It appears top have an electrolumence shifter lighting. But the actual shifter lettering seems very faded or dirty. I was curious if anyone here restores these or can I clean it myself without messing something up??
I am in search of a couple of the sheetmetal clips that fasten the two nuts and studs at the bottom of my fenders. I would like to find the same clip as they are not the same as what is being sold. They are more heavy duty and have bends to make them more solid. I have brand new studs and...
Hello, Just installing my 66 doors. I wanted to ask. My drivers door has the small star wheel on the bottom of the hings and my passenger door has them on the top of the hinge. Also both hinge pins have the crowned end on top. Is that correct??
Thinking of this size for my 66 charger rear. Says I need 8" rims and I was wondering about this being a good fir? Anybody running these and if I buy new 8" rims what should I look to have for backspacing. I currently have 7" rimes and I want to go a little wider? Thanks
For my 1966 Charger. Looking for a drivers side fender top moulding with the curved end to go on the first 12" of the fender top. I need a drivers side. Also, I have a nice passenger side piece if someone wants to trade a drivers side for my passenger side piece. Thanks....
My front bumper just came back from plating. I have bumperettes for the front bumper. I understand the rear are the same? I am trying to figure out where they bolt on to the front bumper. It appears that they actually went right over the two vertical square holes closest to the number plate...
Here is what I got? I am pulling the entire dash to look behind. Have no clue where to start regarding what is correct and what has been added. Wire colors seem to not match my schematic. Have a look and see what you can see?
Setting up 383 with a quickfuel 650 carb and a old edelbrock/chrysler intake. I need a bracket system and throttle plus kickdown for a 727. What are you guys using to achieve this. My original bracket had one tab broken so it is junk. Lokar seems to be a good choice?? Can I get some input...
My hood has had one of the hinge bolts broken off in the hood mounting bar. Someone made a little mess with a welder. So now I need to figure a fix. I notice there seems to be a bar strip of thick steel slid into the hood hollow. There is (1) phillips screw in between where the two bolt...