Separate names with a comma.
Sorry it looks like no good on the proportioning valve
Here are photos of the tail lights- the left side has a small crack in the upper right side and one of the light sockets is worn and cracked
I got everything already but the floor pan section. Could you post up a picture of the toe board drivers side there's a seem there I need about 6 " up and down off that seem edge to tunnel. How much would that cost? Thanks James
Took some pics today - looks like the floor was replaced at some point Let me know what you are looking for
are lower control arms good ?price and pix
The AC control unit is pointing right at the end that seam I need also the a/c control unit I could us if there's no cracks on the face it looks good but kinda hard to tell
So how many inches up from the seam, down from the seam and to each side -there's only one shot at this and I don't want to cut too much or too little
I am going to be doing some parts removal on the car today - let me know if you are still interested how much you want me to remove - give me a start and end point on all 4 sides since there is only one shot at it and I dont want to go too far and it cost a fortune to ship or too small and it doesn't cover the whole area you need
The lower control arms do look good but until I get mine out and assess I am going to hold off on selling them - it should be fine but I just haven't removed them yet
I'll go out and look at what I cut out on mine it's been awhile since I looked at it
Does this have the vinyl top trim piece that goes over the top of the roof? If so, I'll buy it right now.
It had a vinyl too but it was removed before I got it- every piece of trim was already in the trunk - ill look through my stash to see if it's there
OK the metal I needed is easy to fab I'll just make it. Sorry it's been a long time since I looked at that car
Still have the tail lights And rear bumper brackets?
yes still do - haven't been home much since posting between work and kids home for summer
How much shipped to 46237
I'll pull everything out and locate some boxes, weigh and let you know. Parts - tail lights $200 Bumper brackets - $75 But shipping won't be cheap with the weight of the brackets and size of the box and I will have to ship separately to ensure the tail lights do not get damaged.
Are you looking for the vinyl top trim for the half top? There was a full vinyl top that covered the whole roof then what I have which was the half top that went from the back of the back windows over the roof and to the opposite side. There is a chrome trim that goes over the roof and depending on the trim class either terminated there or connected to another father chrome piece that went in front of and at the bottom of the rear windows. This car did not have that one but it did have the thin chrome strip that went over the roof and terminated as a blunted round end on each side
Just let me know I want them.
I found the two piece stainless trim that goes over the roof for the 3/4 vinyl top option. Here is a picture - the trim is like new - not a mark on it. A little buff and it will be show quality. Let me know if this is what you wanted and we can talk price plus shipping