These are what you need. Rock Auto has always had the best price on them if you have more stuff to add to the order to help with shipping.
69 gtx
- Thread starter 69 GTX
- Start date
Thanks! They are on their way.
I picked up a retro looking tach. SW, I put the repop in the dash but they aren't very racer friendly.
I picked up a retro looking tach. SW, I put the repop in the dash but they aren't very racer friendly.
I lost my good friend Randy Sutherland Feb. 7, had his service Feb 17th. He was a good friend for 40 years. He had a 70 Hemi R/T Challenger, 71 matching 440+6 Cuda & Challenger, & 71 Challenger R/T 383, all 4 spd. He a wealth of knowledge on Mopar. He could rattle of codes and options faster than I could list them. He was generous to a fault with his friends. He lost his battle with cancer.
So I realized I didn't run the gauge leads through the face plate so did that today. Had to pull all the senders out pull them back through the firewall, install, & repeat. Took me a couple hours. What's the old saying, one step forward....... Oil & trans temp weren't to bad, but coolant was tougher, had to remove some hoses.
I also worked on tach leads for both. Mechanical gauge lights, and some dash wiring. Coil lead to dash, tach leads to fuse box. Reading up on the Innovative O2 installation, sensors are in the exhaust but I need to install the rest of it. Same with gear vendor.
Back at it tomorrow.
Back at it tomorrow.
- Local time
- 10:37 PM
- Joined
- May 14, 2011
- Messages
- 15,438
- Reaction score
- 26,904
- Location
- On the Ridge, TN
I am very sorry to read of your friends' passing.... prayers to all his loved ones, family and not.
Tim,
So sorry to hear about your friend.
So sorry to hear about your friend.
Sorry and condolences just seem so inadequate, but I'll add mine here. I wish you all peace and warm memories of Randy.
I was going to say may he rest in peace, but in his case, it sounds like he's the type who is up in heaven banging gears and burning tires!
Truly, I offer my sincere condolences.
Hawk
Hawk, that's how all his friends see him! Thanks.
More wiring work today, natural safety harness, more dash wiring, and starting to wire in the Innovative LM2
More wiring work today, natural safety harness, more dash wiring, and starting to wire in the Innovative LM2
Well a little more work today on the X, got the new master cylinder bled, and front brakes bled. Holes in bottom of dash for gauge bracket. Ran some of the harness for the LM-2. Raised the torsion bars a little. More wiring tomorrow.
Anyone have a spare green/blue gauge light cover, or is looking for red ones.
Put a decal on today.
Where can I get one for my GTX?
I think I got it from Cuda Shop
Well the X saw some daylight before going in the trailer today. Did just a little more wiring too.
I definitely have several Green, not sure if I have any blue ones left, since that's what I used...let me know how many green you want and I'll take a look...Rob
Pretty sure I have some if you can't find any closer.
I'll gladly pay you for one!
So I dropped car off yesterday! Had to drive through a little snow but cleared up by the time I got there. Really happy with Keith and the boys. We went over what's to be done and parts. I did get a heart break though. He laid the rear window trim on the Dutchman panel. It fit awful. I had taken trim to body shop when it was painted to check fit. They obviously didn't. So my next question is has anyone ever tried altering the radius just out from the corner on trim?
Similar threads
