70 RR belhousing removal for clutch install ?

[69Bee]

Thank you for all your help, I thought about what you said and i removed starter and bell and bar for the clutch! Seems like i have the whole car ripped apart. New clutch is here and flywheel has been machined, Now lets see if i can get it back together. Not sure if i can post this here but when installing the bushing where the trans input shaft sits do i just load that hole with bearing grease ? or do i Juast need a little worried about it running out and dripping, and is it bearing grease i use ? there seems to be an awful lot in the hole behind the fky wheel, guessing its the crank thing. any suggestions would be appreciated.

You don't need a lot. Just coat the bearing and shaft end lightly, and install.

 

[Marc]

You don't need a lot. Just coat the bearing and shaft end lightly, and install.

Just wanted to thank everyone that helped a rookie like me, especially you Bee for always replying and quickly ! I got the bushing in, wow that was a lot of fun i will tell ya lol. tomorrow i will try doing the flywheel and clutch ! please do not hesitate to check that part of the forum,no doubt i will be asking something lol.