- Local time
- 1:31 AM
- Joined
- Feb 20, 2012
- Messages
- 59,186
- Reaction score
- 204,537
- Location
- Maskachusetts
I'm getting ready to freshen up my bronze Charger, which right now is 2/3 original paint. The car has a fair amount of dings & scratches & is what would be considered a 10 footer. I'm going to do a nice exterior paint job but not get into the jambs, trunk or engine bay because they are fairly presentable as they are. Anyway, check out these two details below, especially the three screws that apparently were put into the vinyl roof to hold it down during assembly. This is something that I never had seen on any other Chargers I've owned.
The black tape is the same as is used inside the door shell that holds the clear plastic in place. I have no idea why that would be placed there when the foam gasket seals the brackets to the bumper.
The black tape is the same as is used inside the door shell that holds the clear plastic in place. I have no idea why that would be placed there when the foam gasket seals the brackets to the bumper.